Plastics Manufacturing Intelligence
On an injection-molding shop floor, cycle-time creep and scrap-per-shot eat margin one shot at a time. Visual Factory reads cycle time and reject counts straight off the press controller, flags drift before it becomes a bin of bad parts, and pins every reject to a machine, tool, and shift, so recovered shots turn into more good parts off the same machines.Half a second of cycle creep on a 30 second cycle is 1.6 percent of the press's capacity gone before anyone notices.
More output from the factory you already have
What connected machine data does for plastics operations:
same factory, same machines, same people.
80%
lower scrap at an interiors molder (1.5% to 0.3%)
Source: MAJiK deployment, interiors molderWhat MAJiK does in plastics
Connect the machines and put real run data to work. The specifics, not generic dashboards.
Read cycle time and reject counts directly from the press controller, any make
Flag cycle-time drift and scrap-per-shot before it becomes a full reject bin
Connect any controller without PLC reprogramming or press downtime
Tie every reject to a machine, tool, and shift for root cause
Where to go next
The products behind this, and the outcomes plants buy them for.